Lucent Technologies STGR-LIM-VD-24, Manual

Page: 88 / 102

............................................................................................................................................................................................................................................................
Examples for configuration of ADSL2+ line
codes
Configuration Examples
6 - 4 363-217-032R9.9.0
Issue 2, March 2006
............................................................................................................................................................................................................................................................
Examples for configuration of ADSL2+ line codes
Introduction
The following example illustrates line code options that are available to support line rates
that are higher than legacy ADSL rates.
Configuration for ADSL2+
Setting the
line-code
in the
line-config
subprofile to
adsl2plus
configures an al-dmt port
to attempt to use the ADSL2+ protocol (ITU-T G.992.5). The line attempts to use this
protocol and does not train if it is unsuccessful.
read al-dmt {1 1 1}
set enabled = yes
set adsl-type = adsl
set line-config line-code = adsl2plus
set line-config rate-adapt-mode-up = automatic-at-startup
set line-config rate-adapt-mode-down = automatic-at-startup
set line-config line-latency-down = interleave
set line-config line-latency-up = interleave
write