Lucent Technologies PortMaster 4, Configuration Manual

Page: 135 / 191

Configuring T1, E1, and ISDN PRI 10-13
Configuring Channelized T1 or E1
3. Set the signaling protocol and the line provisioning.
Command Slotnumber> set Line0 signaling wink|immediate|fxs
4. Set the framing format for the line.
Command Slotnumber> set Line0 framing esf|d4
5. Set the encoding method for the line.
Command Slotnumber> set Line0 encoding b8zs|ami
6. Repeat Steps 2 through 5 for the other three T1 lines on the Quad T1 board.
7. Save the configuration changes and reset the slot.
Command Slotnumber> save all
Command Slotnumber> reset slotSlotnumber
8. Use the following command to display the configuration for each line:
Command Slotnumber> show Line0
Example Channelized T1 Configuration
This example configures Line1 on a Quad T1 board for channelized T1 service using
E & M wink start, extended superframe format, and bipolar 8-zero substitution.
Command> set view 2
Command 2> set line1 inband
Command 2> set line1 signaling wink
Command 2> set line1 framing esf
Command 2> set line1 encoding b8zs
Command 2> save all
Command 2> reset slot2
The following example display shows the output from the show line1 command for
this configuration:
Command 2> show line1
----------------------line1 - T1 Inband DS0 ------------------
Status: UP Framing: ESF Encoding: 8ZS PCM: u-law
Signaling: Trunk E&M wink start Options: inbound calls only
Receive Level: +2dB to -7.5dB
Alarms Violations
---------------------------------------------------------------
Blue 0 Bipolar 0
Yellow 1 CRC Errors 0
Receive Carrier Loss 0 Multiframe Sync 0
Loss of Sync 0