Chapter 4 Configuring Interfaces Using the Console Interface
The Circuit Emulation Interface
4-2
255-700-261
PacketStar
®
8-Port Voice 2-Wire Station Module User Guide
, Issue 1
Release 8.0.0
•
Taking interface(s) out of service
•
Viewing interface(s)
•
Deleting interface(s)
•
Viewing interface statistics
Configuring a Circuit Emulation Interface
This section provides instructions for configuring an I/O module for the cir-
cuit emulation interface.
Begin
Note:
To display the windows for configuring a circuit emulation inter-
face (see Figure 4-1), you must have completed the following
three steps in a previous procedure:
•
Selected the value CircuitEmulation in the Interface Type field on the
appropriate Port and Channel, DS1 Channel, or Virtual DS1 Channel Con-
figuration window of the module that you are configuring for circuit emu-
lation.
Note:
Channel strapping is done before the Apply Configuration step
below. (For instructions, see the Port and Channel Configuration
chapter of this guide).
•
Selected the Apply Configuration command.
•
Selected the Configure Interface command. The Circuit Emulation Inter-
face Configuration window (see Figure 4-1) is displayed. Table 4-1
describes the commands for the window. Table 4-2 describes the fields on
the window.
1
On the Circuit Emulation Interface Configuration window, enter the val-
ues in the fields on this window according to the information provided in
Table 4-2.
2
Select the Apply Interface Configuration command to set the valus
you selected.
3
If your configuration requires you to bring the interface into service at
this time, do so by selecting the
Bring Interface Into Service
com-
mand. For more information on other configuration windows on which
you can bring interfaces into service, see the “Bringing One or More Cir-
cuit Emulation Interfaces into Service” procedure in this guide.
End
