255-700-467
3-11
PacketStar
®
PSAX 4-Port Voice 2-Wire Office Module User Guide
, Issue 1
Release 9.0.0
Chapter 3 Configuring Ports and Channels Using the Console Interface
Configuring the Ports
Commands
Table 3-5 describes the commands on this window:
4
Select the values for the fields on this window from the values given in
Table 3-6.
Figure 3-9. Two Wire Office Port and Channel Configuration Window
Table 3-5. Commands for the Voice Two Wire Office Port and Channel Configuration Window
Command
Function
Apply Port and Channel Config-
uration
Applies the configuration field values you set.
Reset Port and Channel Display
Resets the fields to the last set of saved values.
Bring Interface Into Service
Brings an out-of-service configured interface to in-ser-
vice status. This command is displayed when the [Oper
Status] field is OutOfService. The value InService is
displayed in the [Oper Status] field. When this com-
mand is executed, the Take Interface Out of Service
command is displayed instead.
Take Interface Out of Service
Takes an in-service configured interface to out-of-ser-
vice status. Command is displayed when the [Oper
Status] field is InService. The value OutOfService is
displayed in the [Oper Status] field.
Configure Interface
Displays the Circuit Emulation Interface Configuration
window.
Enter to Card Configuration
Redisplays the Two Wire Office Configuration window.
