Lucent Technologies MLC-model, Programming And Use Manual

Page: 299 / 484

Manual Signaling (F13XX or F13*XX)
5-189
■
A Manual Signaling button does not initiate an intercom call unless you lift
the handset or press
S , press i , and then press the Manual
Signaling button.
■
To respond to a signal, the target extension must place an intercom call to
the person signaling.
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
as
s
and
e
on system phones.)
To program a Manual Signaling button:
1. Press
f 0 0 s s c
at extension
10 or 11.
2. Enter the number of the extension to be programmed with this feature.
3. Press a programmable button.
4. Press
f 1 3
.
5. Dial the two-digit extension number of the target extension. For example, to
identify extension 22 as the target extension, press
2 2
. (Enter
*
before
the extension number if you want to use the button for voice signaling.)
6. Program another button for this extension or exit programming mode.
Using
■
To beep the target extension:
1. While the handset is in the cradle, press the programmed button.
The extension beeps for as long as the button is pressed.
■
To ring or voice signal the target extension:
1. Lift the handset or press
S
.
2. Press
i
.
3. Press the programmed button.
■
To transfer a call to the target extension:
1. While active on the call, press
&
.
2. Press the programmed button.