Setting Up and Testing the MAX Hardware
Installing the MAX in a rack
MAX 3000 Installation and Basic Configuration Guide
2-3
Warning:
Only trained service personnel should open the MAX unit’s case for testing,
maintenance, installation, or any other purpose. Furthermore, only trained service personnel
should replace MAX components.
Removing the system tray
!
Caution:
When accessing the system board or installing cards or modules, be sure to follow
proper procedures (such as using a grounding mat and a wrist strap) to prevent buildup of static
electricity.
To remove the MAX system tray containing the system board from the MAX cover, perform
the following steps:
1
Make sure the MAX power is off and the power cord is unplugged.
Warning:
Failure to turn off the MAX power and unplug the power cord could result in
bodily injury.
2
Facing the back panel of the MAX, locate the screws that hold the system tray and cover
together.
3
Use a #2 Phillips screwdriver to loosen the screws holding the system tray to the cover.
4
Use the system tray pull-ring to slide the system tray a few inches from the cover.
System tray pull-ring
Screws holding system tray to cover
LA
N U
TP
LN
K
CO
L
TX
RX
WA
N 2
WA
N 3
WA
N 4
WA
N 5
WA
N 6
CO
NT
RO
L
SE
RIA
L
DP
LX
10
0B
T
WA
N 1
