Lucent Technologies CAJUN M770, User Manual

Page: 124 / 266

Chapter 9 Managing Static Routing
106 Cajun M770 ATM Switch User’s Guide
To add a new routing entry to the routing table, use the
route add
command
access the module where you want this route to be added.
Note: All ATM addresses that are entered in the routing table must begin with the
AFI that is supported by the switch. The current AFIs supported by a M770 ATM
Switch are 39, 47, and 45. For more information about these AFIs, see Viewing or
changing the switch prefix in Chapter 4 Managing Miscellaneous Commands.
Once routes have been added, you can view them using the
route show
command.
For more information about displaying the routes in a routing table, see Listing the
routing entries in a routing table later in this chapter.
Command:
M15-155s8:/>route add <address> <vport id> [<vport id>...]
Examples:
M15-155s8:/>route add
39.00.00.00.00.00.00.00.01.f6.e0.00.21.11.31.6f.00.28.01 8.1.0
M15-155s8:/>route add
39.00.00.00.00.00.00.00.01.f6.e0.00.22 8.2.0 8.2.3
M15-155s8:/>route add 39.00 8.4.0
Parameters:
<address>
This can be a 19-byte hexadecimal address or a partial
prefix.
<vport id>
A virtual port that will be used to route towards the
specified ATM address.