2
I N S T A L L A T I O N
To Attach
To Remove
6
Mount the telephone on the wall.
Position the telephone base so the mounting studs on
the wall jack fit into the base of the telephone. Slide
the telephone down on the mounting studs until the
phone locks into place.
7
Follow Steps 6 and 7 under “Table/Desk
Installation.”
Belt Clip
If you wish, you can attach the belt clip to the cordless
handset, following the illustrations below.
Wall Installation
1
Follow Steps 1-3 under Table/Desk Installation.
2
Remove the reversible base.
The telephone comes with the reversible base
installed in the table mount position. Remove the
reversible base by depressing the clips on each side of
the base while gently lifting upward. Position the
base so that the thicker end is toward the front of the
telephone (see the illustration).
3
Reattach the reversible base.
•
Insert the tabs of the reversible base into the slots
on the bottom of the telephone base.
•
Gently press the thicker end of the reversible
base until it snaps firmly into place.
4
Connect the power cord.
•
Plug the power adapter into the jack on the back
of the base.
•
Plug the AC adapter into an electrical outlet not
controlled by a wall switch.
NOTE:
Connect power to the base unit before placing
the handset in the cradle.
5
Connect the telephone line cord.
•
Using the short telephone line cord supplied,
insert one end of the telephone line cord into the
telephone jack on the rear of the telephone base.
•
Feed the remaining line cord into the rectangular
opening by pressing the line cord into the
grooves of the reversible base, leaving at least
three inches free. Plug the line cord into the
standard wall jack.