Nordic Installation Instructions
7 |
P a g e
FINISHING THE INSTALLATION
INSTALL THE CANOPY
Loosen the 2 screws from the bottom of the mounting bracket.
Slide the canopy up to the mounting bracket and place the key hole on the canopy over the screw on the
mounting bracket. Turn the canopy until it locks in place at the narrow section of the key holes and secure it
by tightening the 2 set screws. Avoid damaging the electrical wiring prepared previously.
BLADE INSTALLATION
Loosen the 3 blade holders from motor.
Secure the blade to the blade holder by tightening the 2 blade screws with washer. Fig.7
Repeat to install the other blades to the blade holders.
Install the blade assemblies to the motor by tightening the 2 motor screws. Fig.8
Finally, install the bottom cover to the lamp bracket by rotating it clockwise. Fig.9
Fig. 6
Fig. 7
Fig. 9
Fig. 8