GPC2700JD-Grey
Owner’s Manual
10
Step 8
a) Align the holes on the heat insulation panel (AD) with
the holes on the lid (T).
b) Insert the pre-assembled bolt in lid handle (U) with a
heat resistant washer (NN) through the holes on lid (T)
and the heat insulation panel (AD), then seal with a flat
washer (EE), a lock washer (DD) and a bolt (AA).
c) Tighten all bolts by hand until secure.
Step 9
a) Put the lid upon the grill body.
b) Align the holes on the lid hinge with the holes on the grill body
hinge, then insert the pin (PP) into the hinge hole.
c) Insert a hair pin (OO) into the hole on each end of the pins to
fasten the lid and grill body.
Step 10
a) Align the holes on the right handle (AG) with the
hole on the right side shelf (V), then screw a bolt
(AA), a flat washer (EE) and a lock washer (DD)
into each pre-drilled hole. Tighten by hand until
secure.
b) Loosen the four pre-installed bolts on the right
upper frame (J) and allow 1/4 bolt’s length to
extend from right upper frame.
c) Align the holes on the right side shelf (V) with the
bolts extended from the right upper frame. Push
down the right side shelf until it locks into place.
d) Repeat the procedure for the assembly of left
side shelf (W).
e) Tighten all bolts by screwdriver until secure.
8 x pre-installed bolt
