![background image](http://html1.mh-extra.com/html/lts/ptzh213x23/ptzh213x23_installation-manual_1945243013.webp)
Installation Manual of HD-TVI Speed Dome
12
applications, please adopt the water-proof measures. The short-arm wall mount is not
recommended for outdoor applications.
2.3.3
Set the DIP Switch
Set the DIP Set the address and baudrate for the analog speed dome. The default value of DIP
switch is shown below:
Address: 0
Baudrate:2400
Terminal Resistor: OFF
Please refer to the
Section 2.2 DIP Switch Settings
2.3.4
Installing the Speed Dome
The sketched of installing the speed dome are for reference only.
Steps:
1.
Hang the safety rope to the speed dome and then hook to the mount as shown in Figure 2-8.
③
②
①
Figure 2-8
Mount the Dome
2.
Route the cables of the speed dome through the wall mount.
3.
Connect the corresponding video/power/RS-485 cables.
4.
Install the speed dome to the mount, and secure the speed dome by rotating the speed dome
clockwise.
5.
Fasten the two lock screws with the Allen wrench.