LTS LTN07256-R16, User Manual

Page: 71 / 91

Network Video Recorder User Manual
59
Region Entrance Detection
Region entrance detection function detects people, vehicles or other objects which enter a
pre-defined virtual region from the outside place, and some certain actions can be taken when the
alarm is triggered.
Steps
1. Go to Configuration → Event → Smart Event → Region Entrance .
2. Set Camera .
3. Turn on Enable .
4. Optional: Check Save VCA Picture to save the captured pictures of VCA detection.
5. Set the detection rules and detection areas.
1) Set Arming Area . Up to 4 arming areas are selectable.
2) Adjust Sensitivity . Sensitivity : Range [0-100]. The higher the value is, the more easily the
detection alarm can be triggered.
3) Optional: Set Target Detection as Human or Vehicle to discard alarms which are not
triggered by human body or vehicle.
4) Click Draw Area and draw a quadrilateral in the preview window by specifying four vertexes
of the detection region.
6. Set the arming schedule. Refer to Configure Arming Schedule for details.
7. Set the linkage actions. Refer to Configure Alarm Linkage Action for details.
8. Click Apply .
Region Exiting Detection
Region exiting detection function detects people, vehicles or other objects which exit from a
pre-defined virtual region, and some certain actions can be taken when the alarm is triggered.
Steps
1. Go to Configuration → Event → Smart Event → Region Exiting .
2. Set Camera .
3. Turn on Enable .
4. Optional: Check Save VCA Picture to save the captured pictures of VCA detection.
5. Set the detection rules and detection areas.
1) Set Arming Area . Up to 4 arming areas are selectable.
2) Adjust Sensitivity . Sensitivity : Range [0-100]. The higher the value is, the more easily the
detection alarm can be triggered.
3) Optional: Set Target Detection as Human or Vehicle to discard alarms which are not
triggered by human body or vehicle.
4) Click Draw Area and draw a quadrilateral in the preview window by specifying four vertexes
of the detection region.
6. Set the arming schedule. Refer to Configure Arming Schedule for details.
7. Set the linkage actions. Refer to Configure Alarm Linkage Action for details.
8. Click Apply .