pg. 3
Install NVMSv3
After the
NVMSv3
is installed, run the software. Go to Device Management, and
click
‘
Online Device
’. You
should able to see it from the local network section at
the bottom of the page.
(
NOTE
: Set the IP address correctly for your network before adding it)
Remote Configuration
Make sure the device is
Online
.
Scroll to the right on the Device line item and you
should see the configuration (operation) section.
(
NOTE
: If your screen is small and you do not want to scroll to the
right side every time to access the Config button, you could
customize the column (right click the header) to reduce the
display column length. ie: remove the
‘
Firmware Upgrade
’
column.)
Click the Configure button.
