![background image](http://html1.mh-extra.com/html/lts/cmip7442w-28m/cmip7442w-28m_user-manual_1945237073.webp)
User Manual of Network Camera
73
Day/Night Scheduled-Switch
(1)
Draw the detection area as in the normal configuration mode. Up to 8 areas are
supported.
(2)
Select
Scheduled-Switch
for
Switch Day and Night Settings
.
Figure 6-45
Day/Night Scheduled-Switch
(3)
Select the start time and the end time for the switch timing.
(4)
Select the area by clicking the area No.
(5)
Slide the cursor to adjust the sensitivity and proportion of object on the area for
the selected area in the daytime.
(6)
Slide the cursor to adjust the sensitivity and proportion of object on the area for
the selected area at night.
(7)
Set the arming schedule and linkage method as in the normal configuration mode.
(8)
Click
Save
to save the settings.
6.6.2
Configuring Video Tampering Alarm
Purpose:
You can configure the camera to trigger the alarm when the lens is covered and take
alarm response action.
Steps:
1.
Enter the video tampering Settings interface:
Configuration > Advanced Configuration > Events > Video Tampering