Ltl Acorn Ltl-6310-3G, User Manual

Page: 9 / 41

7
SHOT key to play or stop playing when replaying video.

Press REPLAY key to enter REPLY mode (to confirm setting
in menu mode). Press up arrow key and down arrow key to turn
page, left and right arrow key to zoom in and restore picture.

Press MENU key to enter menu, set the parameters to make
camera work as request. Please refer to the section of
Advanced Settings for better operation.

Press key to enter setting of 3G parameters and status,
please refer to section 3.3 Set up 3G Parameters on Camera. .
In the Test mode, you can test the working area of PIR (Passive
Infrared) sensor, specifically the sensing angle and distance.
To
perform the test:

First position the camera at proper height and aim at the region of
interest (ROI).

Walk slowly from one side of the ROI to the other side parallel to
the camera. Try different distances and angles from the camera.

If the Motion Indicator flashes blue, it means that the position you
located is detected by one of the side Prep PIR sensors. If the
Motion Indicator flashes red, it indicates that position is captured
by the main PIR sensor.
The best position to place the camera could be found through this test.
Generally, it is recommended to place the camera at the height of 3 to 6
feet (1 to 2 meters) to the ground.
2.5
Enter Live Mode
Switch camera to the ON position to enter the live mode. The
motion indicator will flash red for about 10 seconds and the camera
starts working after flash. It will immediately take pictures or record
videos when person or animal enters the area of the PIR sensor.
The camera with the double area remote infrared sensing
technology and is able to be triggered and powered on before the
object entering the shooting area, it will shoot immediately when the
object enters the shooting area. It makes the camera is able to capture
the objects which passing by quickly and object would be in the centre
of the picture. If, however the object roams away after a while and
never alert the main sensor, the camera will power off and resume
standby mode, wait to activate to shoot till the object pass by again.