Installation/Use/Maintenance Instructions
Fan coil units VFC, installation in sills
E
LTG Incorporated · PO Box 2889 · Spartanburg, S.C. 29304, USA
VFC_USA_BA (07/19)
Phone 864 599-6340, Fax -6344 · e-mail: [email protected] · Internet: www.LTG-INC.net
Former editions are invalid · Subject to technical modifications
page 30 of 19
Continuation 5.1 Installation / Suspension
Wall mounting - Rear Suspension
For rear suspension, a Z profile is available. It offers the
possibility to subsequently adjust the unit in height by ap
prox. 0.4 “ and laterally, parallel to the wall, by approx. 2 “.
However, the wall clearance cannot be adjusted. There
fore, always state the clearance W between the unit and
the wall in your order.
For stability reasons, this clearance must not exceed
7.9 “ when using the standard version, but for greater
clearances, a reinforced version is available.
If the unit is not supported from below, use a spacer in ad
dition to the wall bracket for safety reasons (consisting of
clamping pieces or clamping brackets and rubber stops).
The unit housing can be supported in the same way on the
front side.
For wall mounting, screws of at least property class M8
(8.8) are to be used to ensure sufficient stability.
B
0.5
2.3
about 2
2.3
L
1
0.
6
2
gusset
only if L > 8 in
Detail X wall bracket
L = W + 0.2 “ for version I
Size
Dim. B in inches
500
14.7
630
3.7
800
26.4
1000
34.3
1250
43.7
W
rubber
stop
W
min
= 0.6 in
X
