Positive (DC+)
Negative (DC-)
UltraBright™ Architectural Dynamic Tunable White
ColorBright™ Dynamic Tunable White
Positive (+)
W
WW
Positive (+)
W
WW
V+
W
NC
WW
or
INSTALLATION
Always pre-test your LED setup prior to permanent installation. This will ensure all components work correctly. Be sure to check the amperage
rating of the LED strip you’ve purchased so the receiver isn’t overloaded (max 6 amps per channel). Turn off the main AC breaker for the line you’ll
be using before installing your low voltage power supply. If you experience any issues at all with your test set up, please be sure to contact us at
After Sales Support.
Unscrew the left and right cover plates on the receiver. This will expose
the Input and Output Power Terminals.
Loosen the Power DC+ and DC- screws and insert the black wire from
your low voltage non-dimmable power supply in the DC- channel and
secure the screw. Then insert the red wire from the power supply in the
DC+ channel and secure the screw.
Turn the main breaker for the AC line back on to power your non-dim-
mable power supply. The red Power Indicator LED will turn on.
Loosen the Output V+, W and WW screws (leave the NC channel closed).
Then connect the + wire from the LED strip to the V+ channel in the
receiver and secure the screw. Do the same to match the rest of the
wires to their respective “W“ and “WW“ channels.
Look at your LED strip carefully and identify the positive (+), W and WW
channels.
Press the Power Button on the remote control, the sync status indicator
light and the LED strip will turn on.
1.
2.
3.
4.
5.
6.
V.2018.10.03
DYN-MZ-COMBO
3
page
support@FlexfireLEDs.com
925-273-9080 opt 2
User Guide
•
Dynamic Tunable White Multi-Zone Combo
