______________________________________________________________________________
Operating Manual ver. SP530A-EN-1.1 |9
Choose a safe mounting location, so as to prevent the cables can be
stepped on or create tripping hazards.
Make sure that the shape and extent of the supporting surfaces are such as
to ensure a safe support.
Connection are made via 3-pin XLR connector.
Before making connection between mixer and active speaker, make sure all
the switches of the speakers are turned off and the mixer volume is turned
down. To avoid a sudden signal, making connection, then turn on the mixer
first and then the speakers. Turn on the amplifier by the power switch to
position 1 (on).
When the system will start turn on 3 LEDs, after a few seconds will stay on
only two or three if the input signal is present, when the amplifier turn on,
start with the preset the previously loaded.
You can now use the system.
If necessary, adjust the volume by adjusting the potentiometer.
If you want to change the preset, follow the instruction below.
LOADING A PRESET
The active preset is indicated by the corresponding LED. It is possible to
change presets by pressing the center pushbutton
P
.
P1
– preset 1 (green): indicates the factory presets
SMOOTH
P2
– preset 2 (green): indicates the factory presets
VOCAL
P3
– preset 3 (green): indicates the factory presets
LOUD
P4
– preset 4 (green): indicates the factory presets
FLAT
