————————————————
Accessories from
—
The Original
——
Rev. 00 16/10/2013
Page 2 of 3
The battery ground should be disconnected before working on electric wiring and switches!
Remove handlebar controls, clutch lever bracket and brake cylinder assy, then remove the original
handlebar.
Assure that the front wheel is free from any load when dismounting top yoke.
To fix top yoke,
first tighten steering head nut up to 15Nm / 11lbf ft, then fix the slider tube clamp bolts. Now tighten
steering head nut up to the required torque, tightening torques refer to the vehicle
manufacturer’s
instruction.
Push Match clamps up towards the top yoke, align them and tighten them slightly. Now install the
tubes with M6x22 and tighten the bolts with 10Nm (7.31lbf ft).
Now you should check the clearance to the tank and faring, therefore you have to mount all controls
provisorily on the clip-on. Fit the brake fluid reservoir as shown underneath.
.
Adjust clip ons by turning the Match clamps on the slider tubes, then tighten the bolts M6x25 with
10Nm (7.31lbf ft). Now drill the bores for the controls and fix them finally. The left grip should be
installed with glue.
