www.LightingServicesInc.com
Page 3 of 6
IS-0139_A
Installing
the Fixture
with the
-00E Fitting
on an LSI
Track or a
-BUSE
fitting on
an LSI
Busway
FOR USE WITH LSI 3, 4, 5, 6, 8, AND 9 SERIES TRACK
AND LSI 20 SERIES BUSWAY SYSTEMS ONLY.
INSTALLATION INSTRUCTIONS:
The track or busway
must already be installed according to code requirements.
When installing or using this track or busway system, basic
safety precautions should always be followed, including the
following:
Read all instructions.
Do not install any part of a track or busway system less
than 5 feet above the floor (8 feet for 277V).
Do not install any fixture closer than 6 inches from any
curtain or similar combustible material.
STEP
ACTION
1
Flip the fitting switch off and open the fitting handle
(
Fig. 4
).
2
Are you using a one-circuit or two-circuit system?
If one-circuit
, make sure the brass contacts that
protrude from the side of the fitting face the copper
busbars inside the track or busway.
If two-circuit
, inserting the fitting in one direction
connects to circuit one. Removing and reversing
the direction of the fitting connects to circuit two.
3
Insert the fitting straight up into the track or busway
until fully seated (
Fig. 5
).
4
Close the handle and flip the fitting switch on (
Fig 6
).
WARNING: Do not look directly at lit LED.
5
To remove the fitting, hold the fixture in place, flip
the fitting switch off, open the handle, and pull the
fitting straight off the track or busway.
Figure 4. Fitting with switch OFF
and handle OPEN.
Figure 5. Inserted fitting
Figure 6. Switch ON, fitting handle
closed
Installing
the Fixture
with a 5AE
Canopy
Before Installing
: Consult the code requirements for fixture
mounting. Mount the fixture to a ceiling constructed of non-
combustible material, away from any flammable materials.
STEP
ACTION
1
Turn off all power to the fixture mount.
2
Unscrew the 2 supplied canopy mounting screws,
and remove the crossbar from the canopy (
Fig. 7
).
3
Attach the canopy crossbar (
Fig. 8
) to a ceiling
junction box with 2 screws (supplied by others).
4
Fasten the power wires (
Fig. 8
) from the junction
box to the LED driver. Secure the driver inside the
junction box with tape supplied, taking care not to
pinch or damage any wires.
(Fig. 8)
Note: Connect green to ground, black to the
circuit line, and white to neutral.
5
Attach the canopy to the ceiling with the 2 supplied
canopy mounting screws.
Figure 7. Fixture mounted on the
5AE Canopy
Figure 8. Junction Box, crossbar,
ground screw (green) and a
transformer/driver secured.
Crossbar
Transformer/
Driver
Ground
Screw
