www.LightingServicesInc.com
Page 2 of 6
IS-0139_A
Changing
or
Installing
the
Reflector
Before Changing Reflector:
To maintain the
fixture’s current orientation, change the reflector
with the fixture in its location. If the orientation
does change, refer to the “Aiming the Fixture”
section of this sheet. Refer to our
Product Catalog
or web site for reflector options.
Follow steps 1, 2, 4, and 5 if you are installing
the reflector for the first time.
STEP
ACTION
1
Turn off all power to the fixture,
including the fixture switch on the
fitting, and let the LED cool.
WARNING: LED and fixture may be
hot.
2
Remove the cylinder housing by
grasping the fitting stem in one hand
and the cylinder housing in the other.
Pull in opposite directions while
rocking the housing gently side to
side. (
Fig. 1
).
3
Remove the reflector by turning it
counter-clockwise, then pulling it out
of the fixture. (
Fig. 2
).
4
Insert the new reflector by lining up
the three tabs with the notches in the
LED Adapter Ring, and rotating
clockwise until it is secured in
place.(
Fig 3
)
5
Close the fixture front by replacing the
cylinder housing. Align the stem
notch to the cylinder housing notch
and push the cylinder housing onto
the stem notch until it clicks into place
and is secured. (
Fig. 1
).
6
Restore power.
WARNING: Do not look directly at
the lit LED.
Figure 1. Cylinder housing loosened and
notches aligned (arrow). Pull off to expose
lamp, or push onto stem to close and secure
housing.
Figure 2. Rotate reflector counter-clockwise to
remove it.
Figure 3. The three notches in the LED Adapter
Ring. Align the reflector tabs with these
notches and rotate clockwise to secure in it.
