LSI LSI53C896, Technical Manual

Page: 83 / 370

Parallel ROM Interface 2-57
available to the LSI53C896. Table 2.7 shows the memory space
associated with the possible values of MAD[3:1]. The MAD[3:1] pins are
fully described in
Chapter 3, “Signal Descriptions.”
To use one of the configurations mentioned above in a host adapter
board design, put 4.7 k
Ω
pull-up resistors on the MAD pins
corresponding to the available memory space. For example, to connect
to a 64 Kbytes external ROM, use a pull-up on MAD[2]. If the external
memory interface is not used, MAD[3:1] should be pulled HIGH.
Note: There are internal pull-downs on all of the MAD bus
signals.
The LSI53C896 allows the system to determine the size of the available
external memory using the
Expansion ROM Base Address register in the
PCI configuration space. For more information on how this works, refer
to the PCI specification or the Expansion ROM Base Address register
description in
Chapter 4, “Registers.”
MAD[0] is the slow ROM pin. When pulled up, it enables two extra clock
cycles of data access time to allow use of slower memory devices. The
external memory interface also supports updates to flash memory.
Table 2.7 Parallel ROM Support
MAD[3:1] Available Memory Space
000 16 Kbytes
001 32 Kbytes
010 64 Kbytes
011 128 Kbytes
100 256 Kbytes
101 512 Kbytes
110 1024 Kbytes
111 no external memory present
*