THE GS320 SYSTEM
2: OPERATION
Units
Battery light
Alarm light
Status light
Figure 1: GS320 Display
2.1 Units
The GS320 indicates wind speed in miles per hour (mph)
or metres per second (m/s). Current units are indicated
by a small green light.
To change units press and hold the
Down
button for
5 seconds. Verify the alarm threshold every time the
current units are changed.
2.2 Alarm Threshold
Press the
Set Limit
button to see the alarm threshold.
eVeRY TIMe THe UnITs aRe CHangeD, THe
lIMIT MUsT be VeRIfIeD anD Re-aDJUsTeD
If ReQUIReD.
NOTE
✓
To change the limit, press and hold down the
Set Limit
button, and use the
Up
or
Down
buttons repeatedly to
increase or decrease the limit.
2.3 Listen-Only Mode
When the GS320 is started, it wakes up the wind speed
sensor programmed to it and takes control of the sensor.
This means that if a second display is programmed
for the sensor, it will take control of it; the sensor will
no longer acknowledge communication from the first
display. The GS320 can be programmed to operate in
“listening mode”. In this mode the GS320 will display
information from the programmed sensor without
becoming the network controller.
A SENSOR CAN HAVE ONLY ONE
NETWORK CONTROLLER AT A TIME.
To ReCeIVe CoMMUnICaTIon fRoM a
sensoR WITHoUT TaKIng ConTRol of
THaT sensoR, THe DIsPlaY MUsT fIRsT
be PRogRaMMeD In “lIsTen-onlY MoDe.”
CAUTION
2.4 Display Settings
This section describes how to manually change the ID
number the GS320 will listen to, and how to change
some other display behaviors. Changing the wind speed
ID number is required only if the wind speed sensor is
changed and the display must be manually set to listen
to another one.
Press and hold the
Up
and
Down
buttons
simultaneously for 5 seconds. The display will beep and
then indicate the currently programmed wind speed
sensor ID number, one digit at a time. The ID number
must contain six digits; if the ID number is 120, the first
three digits are “000.”
1. Press
Set Limit
button to change from one screen to
the next.
2. To change a digit, use the
Up
and
Down
buttons.
“
Ld
” means Listening De-activated (default). Press
Down
to change to “
LA.
”
“
LA
” means Listening Mode Active. Another
GS320 display must be the master of the wind
speed sensor.
“
OS
” means Output Standard: fail safe output
(default). The output provides power when wind
speed is safe, below the limit. Press Down to
change to “
OI.
”
“
OI
” means Output Inverted: the output wire is
energized when wind speed is above the limit.
This could be use to power an external siren or horn.
“
SA
” means Save. When this screen is displayed,
press the
Down
button to save the ID number
and above options and then exit.
“
CA
” means Cancel. Press the
Down
button
to exit without saving. The system will retain the
previously set ID number and options.
Set
Limit
Indicates the digit number
(first “1.”, second “2.”, etc.)
ID number digits
Figure 2: Example of ID number 18820
SkyAzúl, Equipment Solutions
4
www.skyazul.com