©
LSC
®
- www.lightstreamcontrols.com - SC-8 System™ Instruction Manual Page 5
©
LSC
®
- www.lightstreamcontrols.com - SC-8 System™ Instruction Manual Page 6
SC-8 System™
Functions and Controls
1. Power Switch -
This switch turns the power on/off. When
the power switch is lit, the power is on.
2. Latch Buttons -
Pressing the desired button allows you turn the
corresponding channel on. This will be indicated by the Latch
button lighting up. Pressing the button again will turn that channel
off.
3. Pattern Button -
This button is used with the T16F. In master
mode of the T16F, pressing this button can select the chase pat-
tern or scene. To utilize these functions, please connect the T16F
correctly via the 3-pin female DMX connector. For more details,
refer to the T16F user instructions.
4. Stand By Button -
This button is used with the T16F. In master
mode of the T16F, pressing this button can activate 17 chase pat-
tern or 7 fixed scenes. To utilize these functions, please connect
the T16F correctly via the 3-pin female DMX connector. For more
����� ������
����
����
����
����
����
����
����
����
������
������� ����� ��
��� ������� �������
1
4
3
2
8
7
5
6
9
Set Up:
The SC-8 controller is linked to the SRP8 via the included 9-pin com
cable.
1.
Connect the supplied 9-pin com cable from the output of the SC-
8 to the input of the SRP8.
Operation:
After setting up the SC-8 system, basic operation is very simple.
2.
Be sure the main power is off on both units, and connect your
desired lighting effects to the power relay pack.
Notice: There are eight sockets corresponding to the 8 chan-
nels on the controller. The SRP8 also has a uniteruppted 120v AC
socket.
3.
Once you have connected your desired effects to the power pack
you can use the Latch buttons to turn the fixtures on or off. Or, use
the Flash buttons to momentarily turn the fixtures on and off.
4.
You can also use the Pattern and Stand By buttons to select
chase patterns or scenes. The SC-8 controller must be connected
with T16F for this function. Pressing the Stand By button for three
seconds cand activate 17 chase patterns or 7 fixed scenes. When
chase patterns are activated, each tap of the Pattern button will
select a chase.
SC-8 System™
Set Up & Operation
