LS ELECTRIC LSLV-H100 Series, User Manual

Page: 313 / 618

300
Learning Advanced Features
•
FDT-1 and FDT-2 functions are related to the frequency setting of the inverter. If the
inverter enters standby mode by pressing the off key during auto mode operation, FDT-1
and FDT-2 function operation may be different because the set frequency of the inverter is
different compared to the set frequency of the auto mode.
•
If monitoring signals such as ‘Under load’ or’ LDT’ are configured at multi-function output
terminals, signal outputs are maintained unless certain conditions defined for signal cutoff
are met.
5.48.2 Fault Trip Output using Multi-function Output Terminal and Relay
31 PumpClean
Sel Outputs a signal when a pump cleaning function is
in operation.
32 LDT Trip Outputs a signal when an LDT trip occurs.
33 Damper
Control Outputs a signal when a damper open signal is set
at IN-65
–71 multi-function terminals and run
command is on.
34 CAP.Warning Outputs a signal when value of the PRT-85 is lower
than the value of the PRT-86 (CAP life cycle
examination do not operate properly).
35 Fan
Exchange Outputs a signal when fan needs to be replaced.
36 AUTO State Outputs a signal in AUTO mode.
37 HAND State Outputs a signal in HAND mode.
38 TO Outputs a signal at pulse output.
39 Except Date Outputs a signal when operating the exception day
schedule.
40 KEB
Operating Outputs a signal at KEB operation.
41
BrokenBelt Outputs a signal when a Broken belt is in
operation.
OUT-36 Q1
Define Select an output item for the multi-function output terminal (Q1) of the
terminal block. Q1 stands for the open collector TR output.
OUT-41 DO
State
Used to check On/Off state of the D0 by each bit.