Troubleshooting
Transmitter Display does not light when a key is pressed
• Begin a battery charge procedure and check after 30-minutes.
• If the unit still is blank, check the charging power by substituting it with the
charging supply used for the pagers.
• If the supply is good, call LRS, if the supply is bad, either go to your local Radio
Shack and purchase Radio Shack # 273-1611 power supply as a replacement or
call LRS.
Transmitter Display is okay, but the pager does not receive the page.
• Perform a system reset.
• If the page still doesn’t work, be sure the Restaurant ID matches the pagers (see
page 6).
• Call LRS.
Pager Charge Lights do not come on:
1. When placed in charger, do all pagers have a single red charge light lit up?
• If no pagers have a charge light, skip to 2.
• If only some pagers have a charge light that is lit, skip to 3
• If all pagers have the charge light lit up, skip to 4 or 5.
2. You have probably blown the power supply.
3. Please remember that only 30 pagers can be on one 10V power supply. If you
have more than 30 pagers, call Long Range Systems.
4. You probably have a jumper wire that is not connected. Look on the side of your
chargers and verify all wires are connected properly. If they are connected, then
you may have dirty pagers contacts. Using a damp rag, clean the 2 metal contacts
on the back of each pager.
5. The cleaning crew may be disconnecting the pagers after hours. You may also
have the pagers on a circuit that automatically shuts off after hours. Please be
sure that all pagers are plugged in and charging when not in use.
Long Range Systems
9
T9550 LCM User Manual