DRUCK & TEMPERATUR Leitenberger GmbH •
Bahnhofstr. 33 • D-72138 Kirchentellinsfurt • GERMANY
Tel. +49 (0) 7121-90920-0 • Fax +49 (0) 7121-90920-99 • [email protected] •
• www.druck-temperatur.de
www.LR-Cal.net
MANUAL
LLC 100
38
11.6 Cleaning
Your calibrator is powered by rechargeable Lithium-Ion batteries. You can extend
their service life by following these guidelines.
1. New batteries only reach optimal performance after two or three complete
charge-discharge cycles.
2. The batteries can be recharged hundreds of times but will eventually fail.
3. Only use dealer approved batteries.
4. Do not store your calibrator in extreme heat, above 60ºC as the batteries may
become unstable and rupture .
5. Dispose of used batteries in the correct manner
Do not clean the unit while it is switched on. Do not use harsh abrasives or solvents on
the unit especially on the display window. The outside of the unit may be safely wiped
using a damp cloth. Do not attempt to clean the inside of this unit.
11.5 Battery Care
8.0 Datalogging Interface
8.0 Datalogging Interface
12.0 Technical Specifications
This section gives technical data about your calibrator.
Physical
Size: 149x34x77mm without rubber boot, 155x43x86 with rubber boot.
Weight: approx 340 g
Environmental Ranges
Working temperature: 0°C to 50°C Storage temperature (battery included): -40°C to 60°C
;
Humidity: 0 to 85% (non-condensing)
Battery Pack
Type: Lithium Ion Charge time: 5 hours Battery runtime: approximately 8 hours.
;
;
Charger:
Charging input 10 to 15V DC
Mains charger
100 - 240V AC, 0.5A, 50/60Hz,
12V DC @ 1.5A
Input:
utput:
O
Car Charger 12V DC @ 1A with a cigarette lighter plug. .
Protection:
IP54 dust and splash proof. UL94V-0 flame retardant ABS plastic
12.1 General
