NOTE: IN THE INTERESTS OF SAFETY, PLEASE READ THESE INSTRUCTIONS
BEFORE INSTALLATION AND USE.
WARNINGS:
DO NOT COVER.
RISK OF OVERHEATING OR FIRE IF THE
CLEARANCE DISTANCES ARE COMPROMISED
THIS LUMINAIRE IS NOT SUITABLE FOR INSTALLATION IN LOCATIONS WHERE
THERMAL INSULATION IS PRESENT, OR MAY REASONABLY BE EXPECTED
TO BE INSTALLED IN THE FUTURE, OR WHERE THERE IS A LIKELIHOOD OF
OTHER COMBUSTIBLE MATERIAL, E.G. LEAVES OR VERMIN DEBRIS, ETC.
COLLECTING ON OR AROUND THE LUMINAIRE. IT IS NOT SUITABLE FOR
DOMESTIC INSTALLATION OR INSTALLATION IN RESIDENTIAL AREAS OF NON-
DOMESTIC INSTALLATION (RESIDENTIAL INSTITUTIONS, HOTELS, BOARDING
HOUSES, HOSPITALS, ACCOMMODATION HOUSES, MOTELS, HOSTELS AND
THE LIKE.
ALL ELECTRICAL INSTALLATION WORK MUST BE CONDUCTED BY A LICENSED
ELECTRICAL CONTRACTOR ACCORDING TO THE RELEVANT AUSTRALIAN
STANDARD. DISCONNECT POWER BEFORE INSTALLATION OR SERVICING.
NO USER SERVICEABLE PARTS
RISK OF BURN INJURY - During and after operating unit may be hot, always ensure
that unit has been allowed to cool prior to touching or moving.
•
No user serviceable parts inside - risk of electrical shock.
•
Failure to follow these instructions can result in serious injury, electric shock or death.
•
Always isolate the mains supply prior to conducting any electrical work.
•
Disconnect the power supply when conducting any maintenance or cleaning.
•
Always take care when installing at height.
Ensure that the downlight is installed securely and adequately stable.
Warnings & Cautions
Specifications
Wattage: 11W, 15W, 21W, 25W, 28W, 42W
Efficacy: 120Lm/W, 136Lm/W, 129Lm/W
CCT: 3000K/3500K/4000K
Beam Angle: 50°/60°
(more options available)
CRI: >80
LED: Citizen Cob
Voltage: 110-277V 50/60Hz
Power Factor: >0.9
IP Rating: IP54
Dimming: Available on request
DO NOT COVER
Installation Instructions
CAUTION: When installing at height, ensure to follow all required safe installation practices.
Prior to installation ensure that the power is disconnected at the mains to prevent shock or
injury.
1. Unpack LED downlight and discard packaging thoughtfully.
2. Select installation location. A thickness of 1-25mm is recommended.
3. Cut out a 100x100mm (11/15W), 150x150mm (21/25W) or 200x200mm (28/42W) hole into
the ceiling; take care to ensure correct cut-out sizing.
4. Remove reflector for installation as shown - FIG. 1.
5. Feed the cable through the hole and connect the driver to the power source - FIG. 2. &
FIG. 3.
6. Insert downlight carefully into the hole.
7. Tighten screws to secure and lock the downlight into place, as shown - FIG. 4.
8. Attached the reflector back into the downlight - FIG. 5.
NOTE: Ensure that the downlight is installed securely and adequately stable. Do not remove
safety cable attached to reflector (medium and large models only).
1.
3.
2.
4.
11/15W
11/15W
21/25W
21/25W
28/42W
28/42W
