VISIT THE SUPPORT PAGE AT LPTENTUSA.COM / LPTENT.CA FOR MORE INFORMATION ON LP TENT PRODUCTS.
For models: ZP550, ZP330P, ZP440P, ZP550P
Lift the blue handle upwards A) make sure the
aluminum lever guide hooks into the track (B) Pull
down the blue handle until you hear a click (C).
Adjust the height of the tent using the extendable legs. To do this, push the pin on the
leg inwards (A) and slide the lower part of the leg (B). The lower part must slide by itself.
You can choose between 3 height settings. The walls are provided for the maximum
height. (When extending the legs do not stand on the foot plate)
Grasp the handle (A) and hook the aluminum lever guide (B)
to the piece above (C). Then lock the connection brace by
pressing the handle down fully (D).
Repeat on the remaining 3 sides.
ZP automatic locking system
Height adjustment
Position the wall so that the Velcro strip on the top faces the
outside of the tent. Insert the keders into the frame (A) (INSERT
MID FRAME) and attach the Velcro to the roof strip (B) (Inner side).
Insert the wall keders into the frame
Attaching the wall to the bottom of the leg
Wrap the bottom of the wall around the bottom of the leg and
attach it to the inside of the wall. If there is more than one wall,
attach the Velcro to the adjacent wall.
Unzip the two vertical zippers (door only), roll the door/curtain and
hang it with the Velcro strips on the top of the wall.
Opening the door/window wall curtain
Do not force the frame. Close the
frame and check for blockage
WALL INSTALLATION
FRAME DEPLOYMENT
5
Locking scissor reinforcement
6
7
1
2
3
A
A
C
SET UP INSTRUCTIONS
| Strongman (ZP)
A
B
B
B
A
B
D
C
