VISIT THE SUPPORT PAGE AT LPTENTUSA.COM / LPTENT.CA FOR MORE INFORMATION ON LP TENT PRODUCTS.
Open the structure 60% of the way then position 2 (3 for
Hexagon) people face to face, grab the scissors and pull
while backing up.
The center pole lock pin (A) should pass over the scissor
connection (B). Keep pushing the top of the pole up until
you hear a click (C).
Grasp the
handle (A) in the
center of the
tent and unclip
the punch from
its location (B),
then push
vertically (C) to
raise the pole to
its maximum
height. Once the
pole is extended
insert the pin (B)
in the hole.
Do not tighten the Velcro on the roof
during the assembly of the canvas.
Deploying
With two people, open the roof and grab at each corner.
Correctly position the peak and the corners of your top.
Open the frame 40% of the way
Position the frame
Once each corner of the top is correctly placed on the corners of the structure (A) attach the Velcro
straps in the corners like as shown above (B), finally open the tent all the way and attach the
Velcro straps in the center of the valences to the scissors like as shown above (C)
Position the top
Secure the top to the frame
SET UP INSTRUCTIONS
| Strongman (ZP)
FRAME DEPLOYMENT
TOP INSTALLATION
1
2
3
1
2
Locking the center pole
For models: ZP440, ZP460, ZP480,
ZP480R, ZPH550, ZPH660
3
Locking the center pole
For models: ZP330P, ZP440P, ZP550P
4
Place the tent on a flat surface,
standing upright on its 4 feet. Then
loosen the roof strap.
Position the frame
A
B
C
Do not grab or pull at feet.
B
C
A
A
B
B
C
A
