L-INX User Manual
67
LOYTEC
Version 4.0
LOYTEC electronics GmbH
BACnet/IP mode is set to
Broadcast Management Device,
see Section 4.2.11, the BDT
(Broadcast Distribution Table) specifies all other BBMDs of the BACnet/IP network. The
BDT is shown in Figure 53.
Figure 53: BACnet Broadcast Distribution Table.
By clicking
Add Device
new BBMDs (IP address and port) can be added. With
Action on
Selected
and selecting existing entries, certain BBMDs can be deleted again from the table.
To commit the finished table, device must be rebooted (see Section 4.5).
4.2.15 E-mail Configuration
The Web interface provides the e-mail configuration page to set up an e-mail account,
which is used to send e-mails. The content and time when e-mails are sent is configured
through the Configurator software (see Section 6.11). The e-mail configuration page is
shown in Figure 54.
In the field for the outgoing e-mail server, enter the SMTP server of your Internet provider.
Typically, the SMTP server port can be left at 25. In the field
Source E-mail Address
,
enter the e-mail address of the device‘s e-mail account. In the field
Source E-mail Sender
Name
enter a name that the e-mail will display as the source name. Note, that only ASCII
characters are allowed in the name. If replies shall be sent to another e-mail address, specify
this in the
Reply E-mail Address
.
If the provider‘s SMTP server requires authentication, enter the required user name and
password. Note, that only username/password is supported. SSL/TLS authentication is not
supported (e.g., Hotmail, gmail cannot be used).
To verify the e-mail configuration, reboot the device to let the changes take effect and
return to the e-mail configuration page. Then press one of the
Send Test E-mail
buttons.
Note, that a DNS server must be configured in the IP settings (see Section 4.2.4) to resolve
the e-mail server host name. The Web UI displays a warning message at the top of the page,
if the DNS configuration is missing.
