Lowry LDH1001, Manual

Page: 9 / 22

Silent Mode
To reduce the noise output, for example, when being used at night,
the silent mode can be activated. In this mode, the fan speed is slower
and the unit will be running at a lower extraction rate.
Press the Silent button. When the silent mode is selected the light will
display green.
Press the Silent button again to cancel the Silent mode. The unit will
return to the standard fan speed.
The humidity level can be set when the unit is running in Silent mode
using the instructions for “Setting the Humidity”, however the fan
speed and extraction rate will be lower.
Setting the Humidity
The desired humidity level can be set within a range of 35% to 85%
Relative Humidity in 5% increments by pressing the + and – keys.
To select the desired humidity level ensure the unit is not on the
continuous mode. This can be done by checking the CONT button is
not illuminated green. If it is then simply press the CONT button to
de-activate the continuous mode and the green light on the CONT
button will switch off.
Use the Up and Down control pads to select the desired humidity. The
display will flash while the humidity is being set.
For drier air, press the pad and set to a lower percent value(%).
For damper air, press the pad and set a higher percent value(%).
Note: The humidity cannot be set when the unit is operating in
Continuous Mode.
USING YOUR DEHUMIDIFIER
Page 9