Operation & Controls
The control has Braille markings, which allows for easy temperature adjustment in the dark.
The settings are:
0
OFF
1
●
Gentle Heat
2
●●
Medium Heat
3
●●●
Pre-heat - this setting is recommended for Pre-heating the bed 1 to 2 hours before use with
standard bedding.
DO NOT SLEEP WITH YOUR BLANKET ON THIS SETTING.
There is an enclosed red light which illuminates when the blanket is switched on.
NOTE: On initial use it is recommended that the blanket be set on
setting ‘3’ for 2 hour before sleeping on
the bed and then set to
setting ‘1’ for continuous use. Preset on ‘3’ will assist in drying out any moisture
which has been accumulated in the mattress.
You may notice an odour when using the blanket for the first time, due to the insulation material. This is
harmless and will subside quickly.
Care & Maintenance
Before cleaning, ensure the control is set to the
‘0’ Position (OFF) and remove the plug from the wall
socket.
DO NOT ALLOW THE CONTROLLER TO COME IN CONTACT WITH ANY WET SOLUTION.
Lift the tab on the controller attached to the plastic connector on the blanket, carefully pull the plug
connector away from the blanket. The controller MUST never be immersed in water.
The heating wires within the electric blanket are fully water-proof.
Roll up each of the tie tapes before cleaning or storing and secure them to avoid tangling.
Use only the following instructions:
Hand wash or spot clean
Do not machine wash above 40°c
Do not tumble dry
Do not wring
Do not bleach
Do not dry clean
Do not iron
Do not immerse the controller, supply cord or plug in any liquid.
Lift up tab
Pull out connector
Disconnect before cleaning
