7
Jackplate Mount
You can mount the StructureScan transducer inside or outside of the jackplate by
drilling through the jackplate, then inserting bolts though hinge hole in the side of
the bracket mount into the jackplate.
Jackplate Mount Supplies (not included)
M6 or 1/4” Drill bit (Jackplate Mount) pilot holes
1/4” (M6) jackplate mount bolts
To Mount StructureScan on Jackplate:
Choose a transducer location on the inside or outside of the
1.
jackplate.
Adjust the jackplate up and down to make sure the transducer will
2.
not obstruct jackplate movement.
Make sure nothing blocks the
3.
sonar beam on either side of
the StructureScan transducer.
Route the transducer cable to
4.
the location where the LSS-1
will be installed.
Move the transducer bracket
5.
into the desired position and
then use a pencil to mark the
holes through the hinge hole
and hole in the bracket mount
on the side of the bracket.
Using a M6 or equivalent drill
6.
bit, drill the holes into the
jackplate.
Slide the bracket inside the
7.
jackplate and align the bracket
holes with holes you drilled in
the jackplate.
Slide M6 bolts with washers
8.
into each hole on the side of
jackplate.
Guide the bolts through the StructureScan bracket holes.
9.
Place a washer over the end of the bolts and tighten the nuts.
10.
Connect the transducer cable to the LSS-1 sonar port.
11.
StructureScan bracket
mounted inside the
jackplate. The bracket
can also be installed
on the outside of the
jackplate.
Jackplate
