Lowrance StructureScan 3D, Installation Manual

Page: 13 / 20

what is on the left and right side of your boat. Refer to your display
unit's Operation manual for more information.
Direct Step mount (Flush bracket)
X
Ú
Note:
Do not install the transducer under the hull.
You can mount the transducer in either direction; with the cable
coming out towards or away from the transom when installing with
the direct step (Flush bracket) mount.
Ú
Note:
Sonar does not track bottom when the transducer is
out of the water.
Direct step mount bracket and supplies (not included)
Pilot hole drill bit (Direct Step
mount pilot holes for self-
tapping metal screws) Marine high-grade above- or
below-waterline sealant/
adhesive compound
Maximum 5 mm (#10 or 3/16”)
self-tapping metal screws
To direct step mount using flush bracket:
1.
Make sure the boat’s step is the same length or longer than the
transducer.
2.
After selecting a mounting location, route the transducer cable
to the location where the display will be installed.
3.
Attach the transducer to the surface bracket and hold in the
desired position. Use a pencil to mark pilot holes through the
mounting holes on the surface bracket.
4.
Drill the pilot holes.
5.
Apply a marine high-grade above- or below-waterline sealant/
adhesive compound to the pilot holes.
Installation | StructureScan 3D Transducer
13