9
screws). For the two-piece bracket, use the #20 bit (for the #12
screws).
Position transducer mount on transom and mark mounting holes.
Side view shown at left and seen from above at right.
5. Attaching transducer to transom.
A. One-piece bracket:
Remove the transducer from the bracket and
re-assemble it with the cable passing through the bracket over the
bolt as shown in the following figures.
For single frequency Skimmer, route cable over bolt and through
bracket. Side view shown at left and seen from above at right.
Both bracket types:
Attach the transducer to the transom. Slide the
transducer up or down until it's aligned properly with the bottom of
Transom
Transom
Summary of Contents for Skimmer Series
Page 18: ...18 Notes ...
