Lowrance EP-80R TH, Installation And Configuration Instructions

Page: 7 / 32

7
All T connectors on your network probably will be connected to a device.
If you want to add another node to a working network, add another T
connector. T connectors may be purchased from LEI (ordering informa-
tion appears on the back page of this booklet). If you are adding a
Lowrance or LEI NMEA 2000 sensor, it will come with a T connector.
Adding a Network Node
You can add a node to any existing connection, anywhere along the net-
work backbone. This connection could be between a T connector and a
terminator, between two T connectors, between a T connector and a
backbone extension cable or between two extension cables. Wherever you
want to add the new node, separate the sockets of the existing connection
and install the T connector between them.
If you want to add a node at the end of the backbone (network bus) re-
move the terminator from the last connector, like the figure above. In-
stall the new T connector and attach the terminator to the side of the
connector.
In this example, a new device is added to the NMEA 2000 bus by install-
ing a T connector between a T connector and a terminator at the end of
the backbone (network bus).
Additional Network Information
For more information on creating or expanding a network refer to the
NMEA 2000 network setup booklet, part number 988-0154-173, which
came packed with this document.
Existing network
node
Attach
terminator at
end of bus
Use T-connector or double T connector to add
device to bus (maintaining linear architecture)
Backbone cable
to rest of bus
Devices connect to
double T connector
Busse-Yachtshop.de info@busse-yachtshop.de