Maintenance
Safety:
NEVER
perform any maintenance on the LD3SBF without first
following your company’s
LOCK OUT / TAG OUT
procedures.
Replacing Side Belt Gear motor
1.
Disconnect electrical or unplug machine.
2.
Remove side belt drive guard.
3.
Loosen belt by turning locking nut on bottom side of belt arm.
When loosen remove tension by loosing lock nut and turning jacking
bolt towards the center of belt arm. This will remove tension from
belt.
4.
Loosen hardware at rear of belt arm for finger guard. This will allow
the guard to be moved out of the way and remove the provide
clearance to remove the endless belts..
5.
Note height of drive roller on drive shaft for reinstall. Turn drive
roller to access (2) set screws. Loosen (2) set screws and remove
drive roller and key.
6.
Locate motor wire. It may be necessary cut a few wire ties to allow
some slack in the line when removing the motor. Note there location
for replacement later.
7.
Remove motor mounting screws completely then remove motor and
motor spacers.
Chapter
7
Summary of Contents for LD3SBF
Page 31: ...ASSEMBLY DRAWINGS AND SCHEMATICS Chapter 10 ...
Page 39: ......
Page 40: ......