Doc:MSGB102A0205.doc 15/07/11 P. 17/20
4. Configuration of the ATL Remote control program
•
Start the ATL Remote control program from the PC with the modem already connected and powered.
•
Choose the
Configuration-Options
menu
•
Set the
Connection via modem
box from the
General
table.
•
If the
Modem index
table is empty, enter a record with the name of the installation and the phone number
corresponding with the telephone line of the modem connected to the ATL.
•
Click on
OK
to close and save the
Options
window.
5. Online
Connection
•
Choose
Call with modem
from the
Communication
menu
•
From the pull-down box choose the name of the installation to be called. The corresponding telephone
number (previously loaded in the
Modem index
) will be shown in the box below.
•
Click on
Dial
•
At this point, the modem at the PC end calls the ATL modem. After a few rings the ATL modem and the
program switch automatically to the online mode.
•
To end the connection, choose
Modem-Hang up
from the
Communication
menu
In the event of problems…
If during the attempted call the modem connected to the ATL does not ‘ring’, this means that the call fails to
reach its destination. In this case, carry out the following checks:
•
Try dialing the telephone number of the line to which the ATL is connected using a normal telephone.
The modem called should give off sounds that ought to be heard in the handset. If this does not happen,
there are problems on the telephone line or on the switchboard.
•
Check that PC modem is powered and connected with the cable to the correct serial port (the one set in
Communication-Serial port
)
If the modem called rings repeatedly but the connection fails to be established (the window with the wording
‘Connection OK' is not shown):
•
Check the ATL programming (see previous point 2)
•
Check the ATL-modem 51C5 cable
If the wording ‘Connection OK’ is shown on the PC but then the program switches to Offline:
•
Try connecting directly from the PC to the ATL with cable 51C2 and carry out all the checks described in
the ‘Direct RS-232 connection’ chapter
•
Check that the modem is programmed correctly as described in the previous point 1
