R 1 7 3 0 R E M O T E C O N T R O L
Portable 15 Channel Remote Unit
1-15 (O operates all blinds)
2 jogs = 1 movement, up AND down
STEP 1 - PAIRING THE HANDSET WITH THE MOTOR
NOTE: During the setting procedure, the time between
two operations must not exceed 10 seconds as this will
cause the setting up process to quit.
•
Switch on the power to the motor
•
Always press O and + together
•
Select a channel from 1 - 15 on the handset by
pr or -
•
Press the button on the motor and the motor will
jog and beep
•
On the remote, press O and + together twice then
the up or down button once. The motor will jog
twice each time and beep
The motor and remote are now paired.
•
To change direction press and hold the button on
the motor for 4 jogs
STEP 2 - SETTING THE LIMITS
Select the same channel and set the the limit.
•
Press O and + together, then the up button followed by O and
+ together again, the motor will jog and beep
•
Press the Up button and the blind will start to rise
•
Press O and + together and the blind will go into slow jog mode
•
Press the Stop button on the remote and the blind will stop
•
Press and hold the Stop button down until the motor jogs
and beeps, this will set the top limit
•
Press the Down button and the blind will start to go down
•
Press O and + together and the blind will go into slow jog mode
•
Press the Stop button on the remote and the blind will stop
•
Press and hold the Stop button down until the motor jogs twice
and beeps, this will set the lower limit
Setting is complete. For more blinds, select another channel on the remote
and repeat step 2.
Down Button
C (& Setting Button)
Channel -
Setting Button
Stop Button
Up Button
STEP 3 - SETTING A THIRD POSITION
•
Move the blind using the Up and Down buttons the remote to the desired position press Stop
•
Then O and + together followed by the Stop button twice more, this will cause the motor to do 2 jogs and beep
•
To operate the third position, press and hold the Stop button and the blind will move to its third position
•
To delete the third position, press O and + together, followed by the Stop button twice, the motor will do 2 jogs
DELETING A LIMIT
•
To delete a limit, press O and + together followed by the Down button then press O and + together again, the motor will do 2 jogs
DELETING A HANDSET
•
To delete a handset, press O and + together then the stop button followed by O and + together again, the motor will jog twice and beep
ADDING A HANDSET
•
To add a handset, press O and + together twice on the existing handset. Then press O and + together on the new handset, the motor
will jog twice
•
To perform a factory reset press and hold the button on the motor for 6 jogs
Notice: Do not expose the unit to moisture or heat. When
you use the control unit, if operation distance becomes
short and less effective then please replace batteries.
Please recycle old batteries.
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN
INCORRECT TYPE. DISPOSE OF USED BATTERIES
ACCORDING TO THE INSTRUCTIONS.
Input voltage: 3V (CR2430) x1
Transmitting frequency: 433MHz
Transmitting power: 10 milliwatt
Operating temperature: -10
0
c to 50
0
c
Transmission distance: 200 metres open office, 35 metres on two walls
Technical specification
R 1 7 3 5 R E M O T E C O N T R O L
for use with R1725
