WIRING REQUIREMENTS
4 Conductor consisting of:
+
2 Conductor
shielded
, 20 gauge
with 22 gauge drain (microphone
connection)
+
2 Conductor
unshielded
, 18 gauge
(speaker connection)
All in the same jacket
NOTE: If using cable from other
manufacturers, color code may vary.
The Model TLI is a two-way talk/listen remote station consisting of an electret
condenser microphone with pre-amp for line level output and 8” speaker. As a
system, the TLI provides both listen and talkback capabilities between the remote
zone and the Louroe™ base station. There are three configurations in which
Model TLI can be installed:
?
Using VPSC Housing for surface mounting to a wall or ceiling (industrial application)
Model TLI w/VPSC
?
Flush mounted to ceiling using ERD-8 Backbox and BR-8WS/BR-8VP Grill
(commercial application) Model TLI-CF
?
Surface mounted to ceiling using MR-8 Mounting Ring and BR-8WS Grill
(commercial application) TLI-CS. If a vandal resistant grill is required,
request model BR-8VP Grill instead of model BR-8WS.
DESCRIPTION
MICROPHONE CONNECTION
(SEE DIAGRAM PAGE 4)
:
Terminal strip for microphone connection is located on an arm attached to outer rim of speaker and is labeled
A, B, C. Using West Penn 356 or equivalent four conductor cable, connect as follows:
1) Connect RED wire (shielded) to terminal block marked “A” (12 Vdc supply)
2) Connect BLACK wire (shielded) to terminal block marked “B” (audio)
3) Connect DRAIN wire (bare) to terminal block marked “C” (ground)
SPEAKER CONNECTION
:
Using wire nuts, connect speaker wires as follows:
1) White wire of TLI connects to the White wire of West Penn356 (common)
2) Green wire of TLI connects to Green wire of West Penn 356
(SEE DIAGRAM PAGE 4)
Model TLI
without housing
INSTALLATION AND OPERATING INSTRUCTIONS
Page 2 of 8
LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406
TEL (818) 994-6498
FAX
994-6458
website: www.louroe.com e-mail: [email protected]
(818)
®
TLI_inst_4/11
