INTERCONNECTION DIAGRAM
CONNECTING LOUROE MODEL AOP-SP-E (STAND ALONE)
DIRECTLY TO AN IP CAMERA
USING 3-COND. SHIELDED CABLE TERMINATED WITH 3.5mm PLUG
INSTALLATION AND OPERATING INSTRUCTIONS
3.5mm MONO CONNECTION
White Wire
Red Wire
M
O
N
O
Audio In
Audio Out
Red Wire
Black Wire
White Wire
Bare Wire
WIRING REQUIREMENTS
3 Conductor consisting of:
+
2 Conductor
shielded
, 20 gauge
with 22 gauge drain
+
1 Conductor
unshielded
, 20 gauge
All in the same jacket
+12Vdc
+
AUDIO
OUT
AUDIO
IN
TALKBACK
ADJUST
MIC
ADJUST
C
A
SP
B
LOUROE MODEL AOP-SP-E
TO AUDIO IN OF IP CAMERA
TO AUDIO OUT OF IP CAMERA
+12Vdc, 500mA, power required
(AD-1 Power supply included)
Connect to this 2-pin terminal block
IP NETWORK CAMERA
audio input
audio output
ELECTRET
CONDENSER
MICROPHONE
AOP-XD is not used for this application.
12 Vdc power is required to connect the AOP-SP-E directly to
an IP camera or DVR such as AD-1 power supply.
Positive 12Vdc connects to terminal marked “
+
”
Negative 12 Vdc or ground
onnects to terminal marked “
GND
”
(wire with white stripes)
c
An adaptor (mono to stereo) maybe is
needed if the output of the IP camera has
a stereo jack.
Page 5 of 8
AOP-SP-E 8/09
LOUROE ELECTRONICS 6955 VALJEAN AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX
994-6458
Website: www.louroe.com Email: [email protected]
(818)
Two 3.5mm cables are included
that can be use if the distance
between the AOP-SP-E and the IP
camera is 3’ or less. Otherwise, the
recommended cable should be
used and terminated with 3.5mm
mono plugs on both ends.
GND
