Louis 10014799, Instructions For Use Manual, Page: 9 / 46

9
LOUIS BIKER COAT/HELMET RACK SINGLE
1 | Scope of delivery
Fittings are listed in detail in the drawing (page 6)
2 | General information
2.1 | Reading and keeping the instructions for use
These instructions for use apply solely to the Louis Biker Coat/Helmet Rack Single. They contain
important information on handling, safety and warranty. You should read these instructions carefully,
in particular the safety instructions, before using the Louis Biker Coat/Helmet Rack. Failure to
follow these instructions may cause damage to your helmet etc. Keep these instructions for future
reference. If you pass the Louis Coat/Helmet Rack to a third party, you must also hand over these
instructions.
The instructions for use are based on the standards and regulations applicable in the European
Union and reflect the current state of technology. If abroad, you should also observe any country-
specific guidelines and laws.
1 Base plate
2 Arm section with hanger loops
3 Arm section without hanger loops
4 Helmet pad
5 3 wall plugs (8 x 40 mm)
6 3 countersunk head screws (5 x 50 mm)
7 3 M8 x 45 hex bolts
8 2 External toothed lock washer M8
9 2 Internal toothed lock washer M8
10 3 M8 spring washers
11 3 M8 lock nuts
12 6 M8 plastic caps
13 Instructions (not shown)
11
10
7
12
1 4
2
5
6
3
8
9