4
Mount the back post onto the assembly with the remaining two large
screws. Add the drive band to the assembly before you connect the back
post with the last screw.
Tap the threaded insert into the 8
mm hole at the side of the wheel
where the holes for attaching the
axle are. It is deep enough when
the head of the nut is close to the
surface of the wheel; later on
when you fasten the eccentric
bearing on the front side of the
wheel, the nut will be pulled into
the hole completely.
Use the 3 screws 4.5 x 20 mm to
mount the axle onto the wheel.
