7
Take rear uprights AC and DB from box B
and assemble to the lower side rails
(connection A-A and B-B).
Insure that the holes for the connections C,
E, D and F are facing the same direction, so
that the holes for the barrel nuts are at the
same side of the connected parts.
Assemble the rear uprights and lower side
rails on both sides of the loom (Connections
D-D, F-F, C-C and E-E).
First slide the wooden parts over the dowels
and then make the connections with the
threaded rods, barrel nuts washers and cap
nuts.
Slide the cloth advance lever (from box B)
onto the cloth beam (from box C) and make
sure that the ratchet is on the right side of
the ratchet wheel.
Install the cloth beam with the wooden end
into the hole of the right side rail and the
metal end into the circular groove of the left
side rail. Be sure that the big ratchet is
turned in the backward position.
Because the side rails are not tightened yet,
you can push the side rails apart and install
the beam in between them.
Now tighten the left side rail with the two
screws.
The right side rail has to be tightened later,
after the sides of the loom are connected
with the foot and rear rails.
Summary of Contents for Octado
Page 2: ......
