29
Put the shaft of the locking block in the
hole of the lower side rail. Put a screw
hook further back onto the side rail and
hook the spring around it.
Hook the end of the cord that goes to the
locking block onto the threaded hook with
knurled nut on the treadle and guide the
cord over the pulley.
When you push the dobby treadle down,
the block will turn under the lifting treadle.
This block will prevent you from pushing
both treadles at the same time.
In the neutral position there is about 1/4”
(5-10 mm) space between the locking
block and depressed treadle.
Make the cord between locking block and
dobby treadle longer or shorter to adjust
the neutral position of the locking block.
Fine adjustment can be by turning the
knurled nut shown on the previous picture.
Put the carriage bolt of the reversing disk
through the hole in the right hand upright.
Slide the large washer onto the bolt and
then the ½” (12 mm) spacer bushing.
Summary of Contents for Octado
Page 2: ......
