The Remote Has Stopped Working
The remote control has been working properly, however it has suddenly stopped functioning.
Outlined below are several techniques to help diagnose the problem:
1. Point your remote control at one of your cameras, and press and hold the
RETURN
button.
The camera is able to detect the Infrared signal from the Remote Control, and will display on the
Observation Screen as a flashing light.
If the remote control light does not FLASH onscreen, then the batteries in the Remote Control will
need to be replaced.
2. The remote control has the ability to control several Observation Systems at one time with the
push of a button. This is useful if you have several SG19LD800 Series systems installed at one
location - each system can be set to a different ID.
By default, the SG19LD800 Series Observation System is set to System ID #1. If the remote is
NOT set to control System ID #1, it will not function with the unit. To reset the remote control:
I. Confirm that the
R
is white on the bottom onscreen status bar. If the
R
is blue, please proceed
to Step II.
II. Press the
REMOTE ID
button (see next page for Remote Control diagram). The status bar will
display a
GEAR
symbol indicating that the remote is in
Program Mode
.
III. Press the number
1
button on the remote control.
IV. Press the
ENTER
button on the remote control.
V. Press the
RETURN
button on the remote control.
For advanced setup of multiple systems, please refer to the Users’ Manual provided with your
product.
• Indicates the remote is active
with the System
• Indicates the remote is not
active with the System.
