REAR VIEW
1.CO NT R OLS AN D FU N CTIONS
WIRELESS MONITOR
FRONT VIEW
Location of Receiver Monitor controls
2.4GHz Antenna
High gain directional patch antenna
receives A/V signal from the camera.
CRT
5” Diagonal
Brightness Control
Contrast Control
OFF/Volume Control
Channel Selector Switch
Switch for channel 1-2-AUTO selection.
DC Input Jack
Connect the supplied 12-14V 1.2A
AC adapter.
1
2
3
4
5
6
7
8
9
10
Video Output Jack
EAR jack for Video output connection.
Audio Output Jack
EAR jack for Audio output connection.
V-Hold Control
Speaker
Battery Case
DC plug
Bolt.
11
6
11
1
2
3
5
4
7
9
8
10
11
6
3.SYSTE M OPE RATION
OPERATION WITH MONITOR
Be sure to set the Power Switch on the Receiver Monitor and Camera to
the OFF position before proceed following steps.
Both Camera and Receiver Monitor units must be set to same channel.
NOTE
12V 500mA
AC Adapter
Camera
Power Switch
Channel Selector
Switch
Camera
(1) Connect power adapter(12V/500mA) to Camera power input.
(2) Slide the channel selector switch to CH 1~2 of your choice.
Receiver Monitor
(1) Connect supplied power adapter or plug from Battery Case to Receiver Monitor
power input.
(2) Search the channel 1-2 by using Channel Selector Switch on the Receiver Monitor and
Camera and select best one for optimum reception in your area.
(3) The fine tuning knob should be kept in the center position for best reception.
(4) Try to position both the Camera and Monitor as high off the ground as possible for
better reception.
(5) Volume Control--Adjust the knob for desired volume level.
(6) Bright and Contrast Control--If the picture is too bright or too dark, adjust the bright
and contrast controls to suit.
(7) Vertical Hold Control--If picture rolls up and down
(as illustrated) adjust the vertical hold control.
(8) Adjust the antenna direction as necessary.
NOTE
Receiver Monitor
12-14V 1.2A
AC Adapter
or plug from
Battery Case
Video Output Jack
Audio Output Jack
DC Input
Jack
Channel Selector
Switch
Contrast Control
V-Hold Control
12
13
14
12
13
14
Bright Control
