Lorex N861 Series, User Manual, Page: 52 / 138

Motion Detection 12
7. Choose how the system will react when motion is detected:
• Alarm Out: Check the box to activate alarm output devices (not included) when the se-
lected channel detects motion. Select the alarm output devices that will be activated when
motion is detected, then enter the number of seconds the alarm output device(s) will acti-
vate after motion is detected next to
Latch .
• Show Message: Check to enable an on-screen pop-up when one of your cameras detects
motion. On-screen pop-up shows the channels an event occurred on and the type of event.
• Send Email: Check to enable email alerts. You must configure email alerts before you will
be able to receive them (see 16.4.4 Configuring Email Alerts , page 78).
•
Record Channel:
Select the channels that will record when motion is detected on the se-
lected channel. Set the length of recording following a video loss event in the Post_REC
field.
• PTZ Activation: Set connected PTZ cameras to start a tour, pattern, or go to a preset
location.
• Sequence: Sequence mode will begin. Select the numbered tiles next to this option to in-
clude the corresponding channels in the sequence.
• Snapshot: Select the numbered tiles next to this option to save a snapshot of the corre-
sponding channels.
•
Buzzer:
Check to enable the system buzzer.
8. Click Apply .
#LX400113; r. 2.0/56306/56316; en-US 44