To install the camera in the housing (cont’d.):
2. Place the camera and base in the enclosure. Use the
included screws to fix the camera in place (see Figure
2.0).
3. Pass the cables (power and video) through the conduit
cap. Push the cables through the membrane of the
rubber stopper in the conduit plug. Pass cables through
the duct on the bottom of the housing.
4. Screw the conduit cap onto the plug loosely (you can
tighten once the cables are connected).
5. Insert the complete conduit plug into the duct on the
bottom of the housing. The conduit plug should snap
firmly into place. If you have model DAC1721, go to
step
7
. If you have models ACC1721
HB
or DAC1721
HB
, go
to
step 6.
6.
ACC1721
HB
, DAC1721
HB
models only
—Use a
screwdriver (not included) to connect the 24V/AC,
non-
polarized
wiring to the
power input
on the thermostat
control board (see Figure 3.0). Tighten the conduit cap
firm
ly to prevent moisture
and dust from entering (see
Figure 4.0).
7. Close the enclosure firmly and adjust the bracket
until you have the camera and housing in the
desired position. If desired, use a standard lock
(not included) to lock the housing.
Figure 3.0 Connect wires (x2) to power input terminals
Figure 4.0 Feed cables through duct and tighten cap
Contents
Assembling the housing
1 x Screw Kit
1 x Weatherproof Enclosure
To assemble the housing:
1. Mount the wall bracket using the provided screw kit.
Note:
Make sure you have drilled any necessary holes
in your mounting surface and run sufficient lengths of
extension cables (not included) for your camera (not
included).
2.
Use the included screws to attach the enclosure to the
mounting bracket
.
To install the camera in the housing:
1.
Open the enclosure and remove the camera base.
Use the included screws to attach the camera to the
base
.
Figure 1.0 Enclosure base
Figure 2.0 Place camera in enclosure
•
Aluminum-coated housing
•
Ideal for Indoor/Outdoor use
•
Built-in Heater & Blower for use in various
climates*
•
Lockable enclosure keeps your CCTV
investement safe**
•
Includes metal wall-mount bracket
Accessories:
•
Corner Bracket—MNT1721C
•
Pole Bracket—MNT1721P
*Heater and Blower on ACC1721HB and DAC1721HB models
only
.
**Requires optional lock.
1 x Metal Wall-Mount Bracket
Installing the camera
Features:
ATTENTION
- Make sure you have tested the camera
(not included) prior to selecting a permanent mounting
location by temporarily connecting the cameras and
cables to the TV,VCR, DVR or Observation System.
1 x Conduit Cap
(a)
1 x Rubber Stopper
(b)
1 x Conduit Plug
(c)
(b)
(c)
(a)
